
Image Source
DIY is the new trend. You may be able to select the favourite colour of your garage door but installing it all by yourself needs some thinking. However, if you have the will, you can do it yourself. Just make sure you follow the rules and avoid mistakes to stay safe.
To help you in the process, we have listed down the 6 common mistakes that should be avoided while installing a garage door.
6 Garage Door Installation Mistakes

Choosing the wrong tools
Most people choose and use the wrong tools for installing the garage door.
Commonly, the use of nails instead of screws. This might seem small but creates a large difference. It happens due to low information on tools verification and identification. People need to be careful when selecting tools for their garage door. Have a manual of installation and then use the right tools.
Installation single-handedly
Installing a garage door single handedly might seem economical but it is very dangerous. The springs of the door can cause severe injuries if handled by a single person. The weight of the garage door can’t be ignored. Don’t attempt to install the garage door alone and get some help.
Installing the motor centre
The misconception of installing the garage door motor off-centre that will provide more obstructions should be avoided. Both the motor and the lift assembly should be at the centre of the garage door. If it is ignored then the door will bind and buckle, in the end, causing damage to the garage door.
Ignoring the adjustments
Most people overlook the necessary adjustments before installing a proper door. Like, lifting mechanisms should be considered. However, one should check for the adjustments for installation to avoid future damages. Read the manual carefully and check.
Adjusting door in small space
Forcing the door into a small space is not wise at all. While installation, keep the size of the garage door in mind. Don’t visualize the door in a place it can’t fit. Select the place where it adjusts well. Manufacturer’s instructions would help diagnose the correct place for your garage door.
No Steel door stiffener
A stiffener reinforces the door’s top panel. Sometimes, a door stiffener is avoided to save money or considered unimportant. Although, it is highly important for the proper functions of your garage door. Otherwise, the repeated jerks from the motor will make the panel to buckle.
In The End:
If you are able to avoid these common 6 mistakes while installing the garage door then you are good to go. But if the case turns another way, it is never too late to call A1Garage.com in Gresham for garage repair and installation. It will save you time, effort and some unseen injury. As these are only the common mistakes to be avoided but, a person might encounter more than predicted depending on the management of the procedure.
Good Luck!