Are you looking for a cost-effective and quick solution to secure your property in Edmonton? Installing a chain link fence yourself can be an excellent option! Not only is it budget-friendly, but it is also a relatively simple process that can be completed in a weekend. In this blog, we will guide you through the steps of how to install a chain link fence yourself, so you can secure your property with ease and pride.
You will need the following materials to install a chain link yourself:
- Chain link fabric
- Posts (terminal, line, and corner)
- Post Caps
- Tension Bands
- Tension Bars
- Rail Ends and Ties
- Steel or Aluminum Ties
- Concrete Mix
- Measuring Tape
- Posthole Digger or Auger
- Hacksaw or Fence Pliers
7 Steps DIY Guide
Follow the steps below to install a chain link fence yourself:
Step 1: Measure the Area
Before you start purchasing the materials, you need to measure the length and height of the area where you want to install the chain link fence in Edmonton. This will help you determine how much chain link fabric, posts, ties, and other materials you need.
Step 2: Purchase the Materials
Once you have the measurements, purchase the materials required for the installation. You can easily find chain link fence materials in any local hardware store in Edmonton. Make sure to get the right type of posts, ties, and fabric for your fence, depending on the height and weight requirements.
Step 3: Lay Out the Posts
The next step is to lay out the posts to mark the exact location where they will be installed. Start by marking the corners, then the end posts, and finally the line posts. Make sure to keep the same distance between the posts and check their alignment with a level.
Step 4: Dig the Postholes
Using a posthole digger or auger, dig holes for the posts at the marked locations. The holes should be deep enough to reach below the frost line in Edmonton, typically around 3 feet, and wide enough to accommodate the posts and concrete mix.
Step 5: Set the Posts
Place the terminal and corner posts in their respective holes and fill the holes with concrete mix. Make sure the posts are level and straight by checking them with a level. Repeat the process for the line posts.
Step 6: Install the Tension Bands and Bars
Once the concrete has set, you can start installing the tension bands and bars. Slip the tension bands over the posts and secure them in place with bolts. Then, attach the tension bars to the tension bands.
Step 7: Attach the Rail Ends and Ties
Insert the rail ends into the terminal and corner posts and secure them in place with bolts. Then, attach the steel or aluminum ties to the rail ends and tension bars to complete the framework of the fence.
Step 8: Attach the Chain Link Fabric
Unroll the chain link fabric along the length of the fence and attach one end to the terminal post. Then, stretch the fabric tight and attach the other end to the opposite terminal post using steel ties. Repeat the process for the rest of the fence.
Step 9: Add the Post Caps
Finally, add the post caps to the terminal and corner posts to give them a finished look.
Congratulations, you have successfully installed a chain link fence yourself! This cost-effective solution is a quick and easy way to secure your property in Edmonton. With proper care and maintenance, your fence will last for years to come. Visit https://atlanticfence.ca/fence-repair to learn more.
Leave a Reply